DRAFT, not published. Awaiting owner review. Search engines are told not to index this build. Check each figure's date and confidence flag.
EssentialWatts
Affiliate disclosure: some links on this site may earn us a commission at no cost to you. Details.

Updated 2026-11-21 (draft)

Will a power station start my fridge?

A fridge needs several times its running watts for a moment to start. Here is how to check a power station's surge rating, and why some 'surge' numbers do not count.

Run these numbers with your own appliancesOpens the planner preloaded with: Refrigerator, 24 hours. Change any watt or hour figure.

Why a fridge is hard to start

A compressor is a motor. A motor starting from a standstill pulls far more current than it does once it is spinning. For a typical full-size fridge we use a start figure of 1,300 W, against a running draw near 54 W average. That number is third-party and carries medium confidence, because makers do not print it on the label.

The power station’s inverter has two ratings: continuous watts and surge watts. Both have to hold. The surge rating must cover the fridge’s start plus anything else already running. The continuous rating must cover everything running together afterward.

The “lifting” trap

Some makers publish a surge figure measured for resistive loads, such as a kettle, in a “lifting” or “power lifting” mode. It does not describe a motor start. The Bluetti manual for the Elite 200 V2, for example, lists Power Lifting among its modes.

For any unit where the surge figure is missing or is a lifting figure, our planner does not assume it covers a compressor. It checks continuous watts only and says “motor start not published”. That is not a pass. It means the result is unknown, and you should test with your own fridge, ideally while the return policy still applies.

How to read the table

  • Fits or Marginal: the unit passes capacity, continuous watts and surge for the setup shown.
  • No, cannot start the motor: the surge rating, or the continuous rating for lifting-only units, is below the start figure.
  • No, not enough Wh: it starts the fridge but cannot run it for 24 hours.

The calculator lets you change the start figure to match your fridge.

If yours will not start

  • Plug the power station into the fridge before anything else, so no other load adds to the surge.
  • Try a soft-start accessory sold for compressors. We have not tested these and make no claim.
  • Move to a unit with a published surge rating well above the fridge’s start figure.

Which models can start a typical fridge

Setup: Refrigerator, 24 hours. Full-size refrigerator, 54.2 W avg (24 h/day).

ModelWhRuntimeNeedsResultPrice (checked on)
Bluetti Elite 30 V2 288 about 3.5 h 2100 Wh No
cannot start the motor
$299.99
2026-11-21
EcoFlow RIVER 3 Plus 286 about 3.5 h 1850 Wh No
cannot start the motor
$279
2026-11-02 (stale)
Jackery Explorer 240 v2
Sold out
256 about 3 h 2020 Wh No
cannot start the motor
$249
2026-11-21
Bluetti Elite 100 V2 1024 about 11.5 h 2130 Wh No
not enough Wh
$449.99
2026-11-21
Jackery Explorer 1000 v2
Sold out
1024 about 11.5 h 2180 Wh No
not enough Wh
$559
2026-11-21
EcoFlow DELTA 3 Plus
Preorder
1024 about 11.5 h 2150 Wh No
not enough Wh
$719
2026-11-21
Anker SOLIX C1000 1056 about 12.5 h 1990 Wh No
not enough Wh
$499.99
2026-11-21
Anker SOLIX C1000 Gen 2
Preorder
1024 about 12 h 2070 Wh No
not enough Wh
$469.99
2026-11-21
Jackery Explorer 1500 v2 1536 about 16 h 2290 Wh No
not enough Wh
$949
2026-11-21
Jackery Explorer 2000 v2 2042 about 22.5 h 2180 Wh No
idle draw eats the runtime
$999
2026-11-21
Bluetti Elite 200 V2 2074 about 24.5 h 2020 Wh Marginal
motor start not published
$899
2026-11-21
Anker SOLIX C2000 Gen 2
Preorder
2048 about 22.5 h 2180 Wh No
idle draw eats the runtime
$849.99
2026-11-21
Bluetti Elite 300 3014 about 34.5 h 2100 Wh Fits
motor start not published
$1,099
2026-11-21
EcoFlow DELTA Pro 3
Sold out
4096 about 37.5 h 2610 Wh Fits $2,799
2026-11-21
Goal Zero Yeti 1500X
Discontinued
1516 about 18 h 2050 Wh No
not enough Wh
$1,124.89
2026-11-21

Assumptions: 90% usable depth, 85% inverter efficiency, plus each unit's idle draw. Appliance figures are typical and editable, not measured. Runtime is rounded to 0.5 h, Wh to 10. Prices are dated, many are sale prices, and they may have changed: recheck before buying. Figures recompute from the shared data file. Methodology.

Related

Sources