The short answer
For a typical full-size fridge, plan on a power station of about 2,000 Wh to run it for 24 hours, with an inverter that can start a compressor drawing around 1,300 W for a moment. A 1,000 Wh unit runs the same fridge for about 12 hours. A unit with enough watt-hours but a weak inverter may never start it.
Those two limits are separate, and most buying guides only talk about the first. Both numbers are estimates for a typical fridge. Yours may differ, and the section on checking your own fridge below shows how to measure it.
Limit one: watt-hours decide how long
A fridge does not draw its rated watts all day. The compressor cycles on and off. What matters is the average over time. We use 54.2 W average for a modern full-size fridge. The figure comes from a third-party guide (enoughwatts.com) and we rate our confidence in it as medium: real fridges range widely, and older or larger ones draw more. That average is about 1,300 Wh over 24 hours before any losses.
Then come the losses. Our defaults, which you can change in the calculator:
- 90% usable depth. Do not plan on draining a battery to zero.
- 85% inverter efficiency. Converting battery DC to household AC wastes energy.
- Idle draw. The inverter uses power just by being on. In our dataset that ranges from about 5 W to 34 W depending on the unit. At 12 W it adds about 290 Wh over a day, which many runtime claims leave out.
Required battery size for 24 hours is (load Wh divided by 0.85, plus idle Wh) divided by 0.90. For the 54.2 W fridge with a 12 W idle draw, that is about 2,020 Wh. The calculator shows the result for each model we track.
Limit two: surge decides whether it starts
A compressor motor pulls a burst of power when it starts. We use 1,300 W as the start figure for a typical full-size fridge, again third-party and medium confidence (powerstations.reviews). If the power station’s surge rating is below that, the inverter can trip and the fridge does not start, even from a full battery.
One trap: some makers publish a “lifting” surge figure that is meant for resistive loads such as a kettle, not a motor start. For those units we do not assume the surge figure covers a compressor. The planner says “motor start not published” and checks continuous watts only. Treat any such result as “test it before you rely on it”.
The planner adds other running loads to the start surge, because the router and lights are still drawing power when the fridge kicks on.
What to check on your own fridge
- Look for the nameplate inside the fridge door or on the back. It lists amps or watts.
- Run time matters more than a single number. If you have a plug-in watt meter, log it for 24 hours.
- Put it into the calculator. Change running watts, surge and duty to match.
Keeping food safe
Even with a battery, keep the doors closed. USDA guidance says to move food to a cooler with ice if the power will be out more than four hours, and to keep the fridge at 40 F or below and the freezer at 0 F or below. A fridge on a power station is easier to keep within those limits, but it is worth keeping an appliance thermometer inside.
What this page does not cover
Whole-home backup, medical equipment, and well pumps need a different calculation. Do not use a portable power station for life-support equipment without your provider’s advice.